EXTRA 5% OFF SUMMER SALE*
USE CODE 'SUM5' IN THE SHOPPING CART TO APPLY YOUR DISCOUNT
OFFER RUNS UNTIL 1st SEPTEMBER 2026
*Minimum spend £100, online orders only
VECTAIRE 'A' WHITE TIMER 15cm BATHROOM/KITCHEN AXIAL EXTRACTOR FAN A15/6T
VECTAIRE 'A' WHITE TIMER 15cm BATHROOM/KITCHEN AXIAL EXTRACTOR FAN, A15/6T
- Modular axial fans
- 6"/150mm ducting outlet
- 13 models
- IPX4 - Splashproof
- 3 sizes for toilets, shower-rooms, bathrooms, utility rooms and kitchens
- For walls, ceilings or windows (with window kit)
- Standard, Pull Cord, Timer, Humidity Control and PIR
- Exceeds Building Regulations requirements (including new Document F)
- axial fans to exhaust air and fumes directly outside or through short lengths of ducting
- adjustable timer - 3-15 minutes
- dynamic humidistat with night time set back and anti-hunting device
- humidistat fans with anti-vibration gasket
- easy plasterboard ceiling installation with (optional) Ceiling Ring
- window installation uses AWK window kits
- AWKDG double glazing kits available for 10 and 15cm sizes
- whisper quiet operation
- IPX4 - Splashproof - can safely be installed in Zones I and II
- casings from shockproof and heat resistant plastics
- double insulated motors of shaded pole type mounted on self-lubricating, sealed ball bearings for long life
- motors incorporate thermal cut-out
- maximum ambient temperature - 40°C
- Passive Infra Red sensor range 3m/110 degrees
- EN60335-2-80
- EC Low Voltage Directive 73/23-93/68
- EC Directive EMC89/336
- CE marked
- BEAB APPROVED
- A10/4, 12/5, 15/6 - standard
- A10/4C, 12/5C, 15/6C - pull cord
- A10/4T, 12/5T, 15/6T - overrun timer
- A10/4HCT, 12/5HCT, 15/6HCT - humidistat, cord, overrun timer, neon
- A10/4PIR - passive infra red, overrun timer
- A10/4HTPIR - passive infra red, humidistat, overrun timer, neon
General
Back to top
Specification
Back to top
Compliance
Back to top
Range
SELV models available
Back to top
Typical specification
Supply and install an A10/4HCT modular, axial toilet/bathroom/ shower-room fan as supplied by Vectaire Ltd, Lincoln Road, Cressex Business Park, High Wycombe, Bucks, HP12 3RH. The fan is to be suitable for installation either into a ceiling, wall or window, and be complete with an integral, adjustable, dynamic humidistat, an integral adjustable timer and have a pull-cord so that the fan can be operated manually as well as automatically via the humidistat. There should be a neon on the front of the fan to indicate manual control. The fan should be made of shockproof and heat resistant plastic, contain a motor with sealed, self-lubricating bearings and be protected with a thermal cut-out The fan should be double insulated and be suitable for installation into Zones I and II. The fan is to be BEAB Approved and Marked, CE marked, and comply with current EC Low Voltage Directive EMC89/336 and with BSEN60529. The fan should finally comply with Building Regulations requirements for installation into a toilet/bathroom or shower-room
